1. Switch sequence: when opening, first turn on the control computer to make it run normally and then turn on the Best p1.5 led screen products. When shutting down, turn off the LED display first, then turn off the computer. (Turn off the computer first without turning off the Best p1.5 led screen, which will cause high spots on the screen, which may burn the lamp beads for a long time)
2. After the computer enters the engineering control software, the Best p1.5 led screen can be turned on and then powered on. The interval between switching the screen should be greater than 5 minutes.3. Avoid turning on the screen in a completely white screen state, because the inrush current of the system is large at this time.
4. Avoid turning on the Best p1.5 led screen products in an out-of-control state (A. the computer does not enter the control software and other programs; B. the computer is not powered on; C. the power of the control part is not turned on), because the inrush current of the system is large at this time.
5. When the ambient temperature of the Best p1.5 led screen is too high or the heat dissipation conditions are not good, you should be careful not to open the screen for a long time.
6. When a part of the electronic display body of the Best p1.5 led screen appears very bright, you should pay attention to closing the screen in time.
7. The power switch of the Best p1.5 led screen products often trips, and the screen body should be checked or the power switch should be replaced in time.